Service spine, installation bridge and accessories - Flipbook - Page 5
Product specification
Service bridge
for wall-mounting
Zystm Service bridge for wall-mounting is made of
aluminium and comes in either natural anodised
aluminium or powder-coated surface RAL 9016.
Service bridge with space for
outlets behind the panel.
The service bridge is designed such that lighting can be
installed to the top. Lighting options available are either T5
fluorescent lamps with HF ballast or LED lighting at 3000 or
4000 Kelvin.
Sectional drawing of wallmounted service bridge.
179
A
The service bridge can also be furnished without light as
an ordinary electrical duct.
261
74
123
The service bridge is approved for use in GMO classified
areas.
Sectional drawing of service
bridge with technical module
with space for outlets behind
the panel.
A-A ( 1:3 )
184
Outlets for technical gases, water and other media is located
under the panel with the outlets pendant mounted facing
towards the table top, this facilitates ease of connection.
A
Fixtures are mounted using a special bracket and
an open
void behind the panel can be closed between the brackets
A
providing a fully sealed wall-mounted service bridge. If theres
no requirement for outlets to be mounted in the service bridge,
the panel can be installed directly against the wall.
123
184
Below the lighting the panel houses electrical outlets. It
A current with
is possible to separate low current and heavy
an internal partitioning channel. Outlets are mounted as
Clickline and can be installed in any location within the
entire length of the panel.
A-A ( 1 : 3 )
REVISION HISTORY
REV
DESCRIPTION
A
167
Y:TegningerBirgitteNyt katalog 20142414xxx 3d.idw
Re
Godk. af:
BVN
DATE
08-01-2010
AUTHOR
BVN
Tegnet af:
M
BVN
Denne tegning er Zystms eje
Design: Aluminium and steel
REVISION HISTORY
REV
DESCRIPTION
A
Y:TegningerBirgitteNyt katalog 20142412xxx 2d.idw
Revisionsnr:
Godk. af:
Surface: Natural anodised aluminium or powder-coated
white RAL 9016.
DATE
08-01-2010
AUTHOR
BVN
BVN
Tegnet af:
Mounting/installation: Mounted on technical module or
directly on the wall.
Connection: A ”pick-up point” is agreed with the
customer.
ELEC: Option of low and heavy current connection and PDS.
LED lighting: 3000 or 4000 Kelvin. Switch in duct.
Light T5 tube: HF ballast.
Media and installations: Ready for media feed-in through
tubes
Bottom for service bridge can be purchased.
Zystm A/S • Lillelundvej 18-20 • DK 7400 Herning
• Tel.:
9666 6660 • info@zystm.com • www.zystm.com
BACK TO
CONTENT
A
Materiale:
Birgitte
Denne tegning er Zystms ejendom og beskyttet a