Service spine, installation bridge and accessories - Flipbook - Page 4
Product specification
Service bridge
Suspended with cabinets
Zystm’s suspended service bridge is manufactured from
aluminium and available in either natural anodised aluminium or power coated surface RAL 9016.
The installation bridge allows
installation of point suction box
located between the cabinets.
The service bridge is designed to accommodate lighting to
the top. LED lights can be supplied in Kelvin 3000 or 4000,
as required.
The installation bridge can be
supplied with cabinets or if you
prefer a more open laboratory a
shelf can be fitted to the top.
Below the lighting the panel houses electrical outlets. It is
possible to separate low current and heavy current with an
internal partitioning channel. Outlets are mounted as Clickline and can be installed in any location within the entire
length of the panel.
Feed and extraction of technical gases, water and other
media is housed under the bridge and therefore the outlet
is always facing downwards, which facilitates quick connection. Fixtures are installed using a special bracket and it is
possible to close the bridge between fixtures, so that the
installation bridge is completely sealed. If you do not want
fixtures mounted in the installation bridge, you can choose
to install the installation bridge directly against the wall.
Electrical equipment is used in the
clickline or European box, which is
installed directly in the duct.
Fixtures are installed under the
installation bridge with
concealed piping in the center
of the bridge.
The service bridge is approved for use in GMO classified areas.
The service bridge can also be furnished without light as
an ordinary electrical duct.
Design: Aluminium and steel
Surface: Natural anodised aluminium or powder-coated
white RAL 9016.
Mounting/installation: Installed from the ceiling
Connection: A ”pick-up point” is agreed with the
customer.
ELECTRICITY: Option of low and heavy current connection
and PDS.
LED lighting: 3000 or 4000 Kelvin. Switch in duct.
Media and installations: Ready for media feed-in
through tubes
Zystm A/S • Lillelundvej 18 • DK 7400 Herning
Tel.:
9666 6660 • info@zystm.com • www.zystm.com
BACK •TO
CONTENT