Compact laminate - Flipbook - Page 18
PRODUCT SPECIFICATION
JOINING OF COMPACT LAMINATE COMPONENTS
USING BEECH DOWELS & POLYURETHANE ADHESIVE
INDOOR AIR QUALITY SAFETY:
Gas-tight Plug: Inside the enclosed cavity between the
two boards, the adhesive expands to fill all microscopic
air pockets around the beechwood dowel. Any natural
emissions are hermetically encapsulated.
There will be no measurable or harmful emissions from
either the dowel or the cured adhesive once the boards
are pressed completely together. The tight design and
choice of adhesive make the installation exceptionally safe
for the indoor climate.
JOINT CROSS-SECTION & COMPONENTS
TECHNICAL DESCRIPTION
Detailed cross-section of joint with beech dowel (8 × 30
mm) and polyurethane adhesive.
1. PHYSICAL ENCAPSULATION (NO CONTACT WITH AIR)
When two compact laminate boards are pressed tightly together, the joint is sealed off. Airflow around the
dowel and adhesive disappears almost completely. Any
microscopic residual substances from the cured adhesive
or natural aromatic compounds from the beechwood are
literally sealed inside. Since these substances cannot
come into contact with the room’s air, they cannot
evaporate (emit) into the surrounding environment.
2. COMPACT LAMINATE FUNCTIONS AS A BARRIER
Compact laminate is extremely dense and has an exceptionally high material density. The material acts as
a solid, impermeable barrier. Any gas molecules cannot
penetrate through the laminate board itself. The absolute only microscopic pathway out would be the hairline gap where the two boards meet, where emissions
from cured Polyurethane adhesive and beechwood are
virtually zero.
Figure 1: Detailed cross-section of joint with beech dowel (8 × 30 mm) and polyurethane adhesive.
3. COMPLETE CHEMICAL SEAL
A 1-component polyurethane adhesive such as Cascol 1809
is based on MDI isocyanates. Although wet PU adhesive requires gloves and adequate ventilation during application,
a complete chemical transformation occurs as it cures.
Plastic Polymer: During curing, the adhesive reacts
chemically, transforming into a stable, hard, and completely inert thermosetting plastic (polyurethane).
Zero Emissions: Once this chemical process is complete
(after approx. 24 hours), the adhesive is 100% stable. It
no longer releases gases, VOCs, or isocyanates into the
indoor climate.
BACK TO CONTENT